Effects of spray volume, type of surface tissue and inoculum level on the survival of Escherichia coli on beef sprayed with 5% lactic acid

Membrane, fat and cut muscle surfaces of beef were inoculated with Escherichia coli at numbers about 4, 1 or −1 log cfu/cm2. The inoculated meat was sprayed with water or 5% lactic acid at volumes of 0.5, 0.1 or 0.02 ml/cm2. Spraying with water reduced the numbers of E. coli on membrane surfaces by up to 1 log unit, but had little effect on the numbers of E. coli on fat or cut muscle surfaces. Spraying with 5% lactic acid reduced the highest numbers of E. coli on membrane surfaces by up to 4 log units; but those numbers on fat or cut muscle surfaces were reduced by ≤1.5 log unit, and the reductions declined with decreasing volumes of 5% lactic acid. With inocula of 1 log cfu/cm2, spraying lactic acid in any volume reduced the numbers of E. coli on membrane or fat surfaces by about 1 log unit, and the numbers on cut muscle surfaces by between 0.8 and 0.2 log unit. E. coli were detected in enrichment cultures of samples from all surfaces inoculated with E. coli at −1 log cfu/cm2 and sprayed with 5% lactic acid at 0.5 ml/cm2. The findings indicate that spraying relatively heavily contaminated cuts or trimmings with 5% lactic acid at ≥0.1 ml/cm2 can be expected to reduce numbers of E. coli and, presumably, associated pathogens by between 0.5 and 1 log unit. However, such a treatment is likely to be at best marginally effective for reduce the numbers of these organisms on lightly contaminated product.