Mercury speciation and emission from municipal solid waste incinerators in the Pearl River Delta, South China Original Research Article

The potential for Hg release during municipal solid waste incineration (MSWI) is attracting increased attention due to high volume of municipal waste being treated by incineration in China. Emission amounts have been estimated using emission factors developed for other countries. To fine tune our emission estimate total mercury (THg) and mercury speciation were measured using isokinetic sampling in eight plants, of which six used grate furnace combustor (GFC) and two circulation fluidized bed combustors (CFBCs). Results showed that average THg concentration (19.5 ± 13.6 μg/Nm3) in flue gas at the facilities that used CFBC was significantly lower than that at those using GFC (51.4 ± 28.3 μg/Nm3, p = 0.002). Gaseous oxidized mercury (GOM), gaseous elemental mercury (GEM, Hg0), and particulate mercury (Hgp) represented 95.5 ± 3.8%, 4.1 ± 3.9% and 0.4 ± 0.3% in GFC, and 63.8 ± 8.6%, 33.6 ± 10.5% and 2.6 ± 1.9% in CFBC, respectively. The measured average THg emission factor for the 8 MSWI plants was 208 ± 130 mg/t in the Pearl River Delta (PRD) region, with 217 ± 158 mg/t and 188 ± 17.7 mg/t were from GFC and CFBC, respectively. Using the average emission factor the estimated total mercury emissions from MSWI were 4.67 ± 2.91 t in China, and 770 ± 65.5 kg in the PRD region in 2010. Of these, 4240 ± 210 kg, 408 ± 231 kg and 14.8 ± 14.1 kg, and 688 ± 37 kg, 78.9 ± 40.6 kg and 3.2 ± 3.0 kg were GOM, Hg0, and Hgp, respectively. Mercury emissions will continue to increase as the amounts of MSW being incinerated increases.