شماره ركورد كنفرانس :
4120
عنوان مقاله :
WELDING of Cr-Mo STEELS for ENERGETIC INDUSTRY
پديدآورندگان :
KRNIĆ Nikša UNIVERSITY OF SPLIT, FACULTY OF ELECTRICAL ENGINEERING, MECHANICAL ENGINEERING AND NAVAL ARCHITECTURE (FESB), Department of Production Engineering, Welding Laboratory , GAŠPAR Goran INDUSTRIUS Ltd., Bajagić 11, 21241 Obrovac Sinjski and Dolačka 74, 22000 Šibenik, CROATIA , AZIZMORADI Mohammad MACHINE SAZI ARAK Co., 4th km of Teheran Road, Arak, IRAN, M. S. Mech. Eng
كليدواژه :
Low alloyed steels , Cr , Mo steels , Weldability , GTA (TIG) Welding , Welding Procedure Specification , Tubes
عنوان كنفرانس :
هجدهمين كنفرانس ملي جوش و بازرسي و هفتمين كنفرانس ملي آزمايش هاي غير مخرب
چكيده فارسي :
Paper gives an overview and main characteristics of low alloyed steels based on chromium and molybdenum as the main alloying elements. Chrome-moly steels are intended for high temperature applications especially for the need of energetic industry. Welding issues of these steels is presented and general recommendations for welding of CrMo steels are presented. In experimental part of this paper GTA welding of 10 CrMo 9 10 tubes in 5G position were performed in such a ways that approved welding procedure specification (WPS) was, regarding thermal conditions and prerequisites disobeyed, (no preheating and no control of interpass temperatures) without and with tubes restrain and with complete obeying of WPS using restrain. Disobeying adequate welding procedures can result in detrimental quality loss by welding of 10 CrMo 9 10 tubes.
