شماره ركورد كنفرانس :
4619
عنوان مقاله :
Effects of Flowrate and Wettability on Ultimate Oil Recovery during Nanofluid Injection into Glass Micromodel
پديدآورندگان :
Ziarati Abolhassan abolhasanziarati007@gmail.com School of Chemical Engineering, College of Engineering, University of Tehran, Tehran, Iran , Hosseinpour Negahdar nhosseinpour@ut.ac.ir School of Chemical Engineering / Institute of Petroleum Engineering, College of Engineering, University of Tehran, Tehran, Iran , Bahaloo Horeh Narges School of Chemical Engineering, College of Engineering, University of Tehran, Tehran, Iran
كليدواژه :
Nanofluid Injection , Glass micromodel , Recovery factor , Water , wet , Mixed , wet
عنوان كنفرانس :
دومين كنفرانس بين المللي دو سالانه نفت، گاز و پتروشيمي
چكيده فارسي :
Most of the oil reservoirs are reaching the decline period of their life. Many researchers have observed nanoparticles increase the recovery factor by IFT reduction between the water-based injected fluid and the residual oil, changing the wettability of porous media and increasing the viscosity of the injection fluid In this experiment, glass micromodel was used instead of a core as porous media due to its displacement mechanisms visibility. First, micromodel was saturated with 19゚ API, and then, water-based silica nanofluid with a concentration of 100 mg/l was injected at different rates of 0.03 and 0.05 cc/h into water-wet and mixed-wet micromodels Results show that maximum ultimate recovery is obtained at water-wet condition and flowrate of 0.03 cc/h As a conclusion, the higher rate has higher shear stress that has a bad influence on nanoparticles stability and water-wet micromodel helps much better to recover the residual oil
