شماره ركورد كنفرانس
5048
عنوان مقاله
Application of taguchi method in the optimization of treatment of wastewater contaminated with MTBE by UV/H2O2 process
Author/Authors
A ،Niaei Department of Applied Chemistry and Chemical Engineering - Faculty of Chemistry - University of Tabriz, Tabriz, Iran , D ،Salari Department of Applied Chemistry and Chemical Engineering - Faculty of Chemistry - University of Tabriz, Tabriz, Iran , F ،Aghazadeh Department of Applied Chemistry and Chemical Engineering - Faculty of Chemistry - University of Tabriz, Tabriz, Iran , F ،Seyednajafi Tabriz petrochemical company, Tabriz, Iran , N ،Kazemian East Azarbaijan State Water & Waste Water Company, Tabriz, Iran , A ،Jodaei Department of Applied Chemistry and Chemical Engineering - Faculty of Chemistry - University of Tabriz, Tabriz, Iran
كليدواژه
MTBE , Advanced oxidation processes , Fuel oxygenate , Taguchi method
سال انتشار
1388
عنوان كنفرانس
ششمين كنگره بين المللي مهندسي شيمي
زبان مدرك
انگليسي
چكيده فارسي
فاقد چكيده
چكيده لاتين
The Taguchi experimental design method was applied for the systematic and effective investigation of the optimal
treatment conditions of wastewater contaminated with MTBE by UV/H2O2 process, which would be affected by various
parameters, such as MTBE concentration, H2O2 concentration, time, distance between solution and UV lamp and initial
pH. From the results of sixteen experimental runs, for the evaluation of five factors and four levels, having the
equivalent effects of 1024 experimental runs, the following results are derived. Most of the experimental conditions in
this study showed good results at the low distance between solution and UV lamp and the long time of UV irradiation.
Optimum operating conditions for MTBE removal were MTBE concentration 250 ppm, H2O2 concentration2.5 mmol,
time25 min, distance between solution and UV lamp7 cm and initial pH 7. The percentages contribution of parameters
was also investigated.
كشور
ايران
تعداد صفحه 2
5
از صفحه
1
تا صفحه
5
لينک به اين مدرک