شماره ركورد كنفرانس :
5536
عنوان مقاله :
Influence of Speed Print and Raster Angle on the Mechanical Properties of ABS Polymer Parts Produced by Fused Deposition Modelling
پديدآورندگان :
Bazraee Sabereh Department of Mechanical Engineering, Bu-Ali Sina University, Hamedan, Iran, 65175-4161 , Seifi Rahman rseifi@basu.ac.ir Department of Mechanical Engineering, Bu-Ali Sina University, Hamedan, Iran, 65175-4161 , Bazraee Saeed Novel Drug Delivery Department, Iran Polymer Petrochemical Institute, Tehran, Iran, 14965/115
كليدواژه :
3D printing , FDM , Tensile strength , Raster angle , Print speed
عنوان كنفرانس :
پانزدهمين همايش بين المللي علوم و فناوري پليمر
چكيده فارسي :
The additive manufacturing process (AM) is less expensive, quicker, and more flexible than conventional fabrication techniques, and the most common additive manufacturing technique is FDM. However, several parameters influence the printed sample properties, including mechanical, physical, and thermal properties. In this work, we studied the impact of print speed and raster angle on the mechanical properties of the printed acrylonitrile butadiene styrene (ABS) samples. Thus, the printed samples by FDM methods were analysed via tensile test. The results showed a peak in the elastic modulus at 2400 mm/min. Furthermore, changing the raster angle from +45/-45 to 0/90 significantly reduced the elongation at the breaking point.
