Author/Authors :
KIVAK, Turgay Düzce Üniversitesi - Cumayeri Meslek Yüksekokulu - Makine Bölümü, Turkey , HABALI, Kasim Gazi Üniversitesi - Teknik Egitim Fakültesi - Makine Egitimi Bölümü, Turkey , SEKER, Ulvi Gazi Üniversitesi - Teknik Egitim Fakültesi - Makine Egitimi Bölümü, Turkey
Title Of Article :
INVESTIGATION OF THE EFFECT OF CUTTING PARAMETERS ON SURFACE ROUGHNESS AND CHIP FORMATION IN DRILLING OF INCONEL 718 SUPER ALLOY
شماره ركورد :
16369
Abstract :
In this study, the effects of cutting parameters on surface roughness and chip formation obtained during the drilling of Inconel 718 super alloy with coated and uncoated carbide drills were investigated. Drilling tests were performed using TiN and TiAlN coated carbide drills on a vertical CNC machining center with four different cutting speeds (10, 12,5, 15, 17,5 m/min ) and three different feed rates (0,05, 0,075, 0,1 mm/rev). Blind holes with 8 mm depth were drilled with 5 mm diameter drills. Surface roughnesses evaluation of holes based on the cutting tools was made with respect to the roughness measurements. According to this evaluation, the best results for surface roughness on the holes were obtained with the ones drilled by uncoated carbide tools. When the chip formations were examinated, for all tests the chip formations for the first drilled holes were a discontinuous chip form or tight helical chip form.
From Page :
293
NaturalLanguageKeyword :
Inconel 718 , surface roughness , chip formation , drilling.
JournalTitle :
Journal Of The Faculty Of Engineering an‎d Architecture Of Gazi University
To Page :
298
Link To Document :
بازگشت