Author/Authors
TOPRAK, İ. Burcu Akdeniz Üniversitesi - Teknik Bilimler MYO - Kontrol ve Otomasyon Teknolojisi Programı, Turkey , ÇAĞLAR, M. Fatih Akdeniz Üniversitesi - Teknik Bilimler MYO - Kontrol ve Otomasyon Teknolojisi Programı, Turkey , ÇOLAK, Oğuz Akdeniz Üniversitesi - Teknik Bilimler MYO - Kontrol ve Otomasyon Teknolojisi Programı, Turkey , KIRAN, Kadir Akdeniz Üniversitesi - Teknik Bilimler MYO - Kontrol ve Otomasyon Teknolojisi Programı, Turkey , BAYHAN, Mustafa Akdeniz Üniversitesi - Teknik Bilimler MYO - Kontrol ve Otomasyon Teknolojisi Programı, Turkey
Title Of Article
OPTIMIZATION OF SURFACE ROUGHNESS BY USING TAGUCHI METHOD IN MILLING OF TI-6AL-4V SUPER- ALLOY AT HIGHPRESSURE COOLİNG CONDITIONS
شماره ركورد
35780
Abstract
In this study, effects of cutting parameters on surface roughness during the milling of the super alloy, Ti-6Al- 4V, using highly-pressurized cooling have been investigated and the optimum processing conditions have been detected. Cutting speed, feeding rate, cooling fluid pressure value have been expressed at four different levels and the experimental design has been achieved by Taguchi L16 orthogonal sequence. At the end of the experiments, variance analysis (ANOVA) was performed for the surface roughness values obtained based on the cutting parameters and the effect of experimental parameters on surface roughness has been investigated. Moreover, optimum cutting conditions have been defined for minimum surface roughness, depending on signal/noise (S/N) ration, using the Taguchi optimization method. Finally, it was detected that the optimization was applied successfully, by performing verification experiment under optimum experimental conditions.
From Page
30
NaturalLanguageKeyword
Milling , highly , pressurized cooling , Variance Analysis (ANOVA) , the method of Taguchi , surface roughness.
JournalTitle
Sdu International Technologic Science
To Page
39
JournalTitle
Sdu International Technologic Science
Link To Document