The trap-loaded cylindrical antenna

The trap-loaded cylindrical antenna is a cylindrical antenna having one or more traps located in its arms. The traps are either parallel inductor-capacitor circuits or short-circuited transmission line stubs that are designed to be antiresonant (having essentially an infinite input impedance) at some particular frequency. The location and the antiresonant frequency of the traps are selected to enhance the radiation pattern or input impedance of the antenna. This study is confined to the properties of trap-loaded cylindrical antennas that contain only one trap in each arm. The effect of the length of the outer section, length of the inner section, diameter of the cylinder and characteristic impedance or inductance-capacitance ratio of the trap on the input impedance, radiation pattern, and current distribution were studied both experimentally and with the aid of two numerical solutions of an integral equation for the current distribution. The conclusions drawn from this study are that the design procedure for the multiband trap antenna described by Greenberg [1], adjusting the antiresonant frequency of the trap to control the upper resonant frequency, is indeed valid. Graphs suitable for designing trap antennas using this procedure are available in this paper. Furthermore, it is shown that the characteristic impedance or inductance-capacitance ratio of the trap can also be adjusted to vary the lower resonant frequency of the antenna. Design graphs using this procedure are also available in this paper. This study also showed that a relatively wide range of upper to lower antenna resonant frequency ratios can be obtained while still maintaining radiation patterns and input impedances close to those of a half-wave dipole at both frequencies. Graphs are available showing the tradeoff in pattern shape and input impedance that must be made to obtain resonant frequency ratios other than 2 to 1. It was discovered that the trap antenna, sometimes called a Franklin array, must be operated somewhat below the nominal design frequency or have the spacing between traps shortened somewhat, for it to have a radiation pattern similar to a collinear array of half-wave dipoles. Furthermore, the thicker the antenna, the more pronounced this effect is. While the nominal design was- discovered to give an input impedance nearly resistive and near (for a dipole), any of the aforementioned modifications resulted in a nonresonant highly capacitive input impedance.