DocumentCode
1057907
Title
A High Reliability High Sensitivity Lightwave Receiver for the SL Undersea Lightwave System
Author
Snodgrass, Michael L. ; Klinman, Richard
Author_Institution
AT&T Bell Laboratories, Allentown, PA
Volume
2
Issue
6
fYear
1984
fDate
11/1/1984 12:00:00 AM
Firstpage
1008
Lastpage
1014
Abstract
Undersea lightwave systems need receivers with the utmost in both reliability and sensitivity. Our design has evolved from the type which we provided for an earlier deep-sea trial. The primary features of our present receiver are an InGaAs planar p-i-n photodiode with passivation and antireflection coating and a Si bipolar integrated circuit, both encapsulated in a special chip carrier. Both the photodiode and the amplifier are placed in the same carrier so that a direct chip-to-chip wire bond can minimize stray capacitance, which helps to maximize sensitivity. The back-illuminated structure of the photodiode allows the InP substrate to serve as a window in the hermetically sealed carrier. Since both active devices are in a separate package from the passive components, they can undergo the high temperature bake-out and hermetic seal followed by the high temperature high bias. purge necessary to assure the reliability of the semiconductors. This optical chip carrier is then mounted inside another hermetic package which contains the passive components, including the optical fiber pigtail, which must undergo bake-out and seal at more moderate temperatures. Within the constraints of reliability, bandwidth, and dynamic range, the physical structure of the integrated circuit and its bias conditions have been chosen to maximize sensitivity. The design of the circuit enables us to select those devices from a production lot which will achieve the highest sensitivity in a completed receiver. This receiver is used in systems operating with NRZ data from 140 to 440 Mbit/s. At 1.3 μm and 296 Mbit/s the mean sensitivity achieved was an average optical power
dBm for a 10-9bit error rate (BER), with a best value of -36.3 dBm. This receiver is physically robust, being able to withstand stresses well in excess of those encountered in actual use. Preliminary aging data indicate that a long-term failure rate of less than 2.5 in 109d- vice hours can be achieved.
dBm for a 10-9bit error rate (BER), with a best value of -36.3 dBm. This receiver is physically robust, being able to withstand stresses well in excess of those encountered in actual use. Preliminary aging data indicate that a long-term failure rate of less than 2.5 in 109d- vice hours can be achieved.Keywords
Optical fiber receivers; Semiconductor device packaging; Underwater optical fiber systems; Bit error rate; Hermetic seals; Indium gallium arsenide; Integrated circuit reliability; Optical receivers; Optical sensors; PIN photodiodes; Passivation; Semiconductor device packaging; Temperature sensors;
fLanguage
English
Journal_Title
Selected Areas in Communications, IEEE Journal on
Publisher
ieee
ISSN
0733-8716
Type
jour
DOI
10.1109/JSAC.1984.1146141
Filename
1146141
Link To Document