40 Gb/s Transimpedance-AGC Amplifier and CDR Circuit for Broadband Data Receivers in 90 nm CMOS

High-speed front-end amplifiers and CDR circuits play critical roles in broadband data receivers as the former needs to perform amplification at high data rate and the latter has to retime the data with the extracted low-jitter clock. In this paper, the design and experimental results of 40 Gb/s transimpedance-AGC amplifier and CDR circuit are described. The transimpedance amplifier incorporates reversed triple-resonance networks (RTRNs) and negative feedback in a common-gate configuration. A mathematical model is derived to facilitate the design and analysis of the RTRN, showing that the bandwidth is extended by a larger factor compared to using the shunt-series peaking technique, especially in cases when the parasitic capacitance is dominated by the next stage. Operating at 40 Gb/s, the amplifier provides an overall gain of 2 kOmega and a differential output swing of 520 mV_pp with for input spanning from to . The measured integrated input-referred noise is 3.3muA_rms. The half-rate CDR circuit employs a direction-determined rotary-wave quadrature VCO to solve the bidirectional-rotation problem in conventional rotary-wave oscillators. This guarantees the phase sequence while negligibly affecting the phase noise. With 40 Gb/s 2³¹ - 1 PRBS input, the recovered clock jitter is and 0.7ps_rms. The retimed data exhibits 13.3 ps_pp jitter with BER . Fabricated in 90 nm digital CMOS technology, the overall amplifier consumes 75 mW and the CDR circuit consumes 48 mW excluding the output buffers, all from a 1.2 V supply.