Direct Encapsulation of Organic Light-Emitting Devices (OLEDs) Using Photo-Curable co-Polyacrylate/Silica Nanocomposite Resin

Direct encapsulation of organic light-emitting devices (OLEDs) was realized by using highly transparent, photo-curable co-polyacrylate/silica nanocomposite resin. Feasibility of such a resin for OLED encapsulation was evaluated by physical/electrical property analysis of resins and driving voltage/luminance/lifetime measurement of OLEDs. Electrical property analysis revealed a higher electrical insulation of photocured nanocomposite resin film at 3.20times10¹² Omega in comparison with that of oligomer film at 1.18times10¹² Omega at 6.15 V to drive the bare OLED. This resulted a lower leakage current and the device driving voltage was efficiently reduced so that the nanocomposite-encapsulated OLED could be driven at a lower driving voltage of 6.09 V rather than 6.77 V for the oligomer-encapsulated OLED at the current density of 20 mA/cm². Luminance measurement revealed a less than 1.0% luminance difference of OLEDs encapsulated by various types of resins, which indicates that the photo-polymerization takes very little effect on the light-emitting property of OLEDs. Lifetime measurement of OLEDs found that , the time span for the normalized luminance of device drops to 80%, for nanocomposite-encapsulated OLED is 350.17 h in contrast to 16.83 h for bare OLED and 178.17 h for the oligomer-encapsulated OLED. This demonstrates that nanocomposite resin with optimum properties is feasible to OLED packaging and a compact device structure could be achieved via the method of direct encapsulation.