Temperature and density measurements in a non-axisymmetric, continuously operating fusion experiment using a heavy ion beam probe

Two-dimensional electron temperature and density data have been obtained in the midplane of the non-axisymmetric magnetic confinement device ELMO Bumpy Torus (EBT) through the use of a heavy ion beam probe. This beam probe differs from others operated on toroidal or open magnetic geometries in its combination of complete computer control with the steady-state nature of EBT which allows, under normal operating conditions, for extensive calibration of the system in situ, minimizing both alignment and acquisition errors, along with the use of synchronous detection to dramatically improve the quality of the detected signal over what is typically possible in fast pulse devices. These techniques are important and applicable to long pulse devices where the beam probe may be an ideal diagnostic to measure, for example, parameters of the edge plasma. While the EBT beam probe was implemented to obtain profiles of plasma space potential, we have found that it can also be used effectively to measure the temperature and density profiles in the midplane between magnetic field coils. The data obtained support the contention that the formation of a hollow temperature profile in the T-Mode sufficiently inverts the plasma pressure such that stability of the core plasma would be expected even without diamagnetic effects from the hot electron rings which have previously been considered essential