Control of polishing of diamond films using microactuation and an atmospheric pressure plasma

In this work, the diamond deposited by hot filament chemical vapor deposition (CVD) is polished using an atmospheric pressure plasma. In order to position the film relative to the plasma, a microactuator system is designed using a stack of domed piezoelectric actuators. A dynamic model based on the physical system is developed and the model parameters are measured experimentally. A system based on laser triangulation is used to measure the position of the diamond film relative to the plasma. Control techniques are used to reduce the oscillations during actuation and to eliminate the steady state positioning error. With the application of feedback control, the overshoot is reduced to 2% and the settling time is reduced to 0.3 s. A preliminary set of experiments is performed to relate process parameters to the final surface roughness of the diamond film. The parameters studied include the film´s time of exposure to the plasma, the height of the film relative to the plasma, and the distance from the film to the center of the plasma. It is found that the optimum exposure time is 15 min and the reduction of surface roughness is greatest when the distance between the film and the plasma is at a minimum. The best results are obtained when the top of the film is even in elevation with the tip of the top electrode. The diamond film is translated laterally along the plasma. When feedback control is not used, there is no change in the surface roughness. With feedback control implemented, the surface roughness of the diamond film is reduced by 33%.