Theoretical, numerical, and experimental investigation on resonant vibrations of piezoceramic annular disks

In this study, vibration characteristics of thin piezoceramic annular disks with stress-free boundary conditions are investigated by theoretical analysis, numerical simulation, and experimental measurement. The non-axisymmetric, out-of-plane (transverse), and axisymmetric in-plane (tangential and radial extensional) vibration modes are discussed in detail in terms of resonant frequencies, mode shapes, and electrical currents. Two optical techniques, amplitude-fluctuation electronic speckle pattern interferometry (AF-ESPI) and laser Doppler vibrometer (LDV), as well as the electrical impedance measurement are used to validate the analytical results. Both theoretical and experimental results indicate that the transverse and tangential vibration modes cannot be determined by the impedance analysis; hence, only resonant frequencies of extensional vibration modes are presented from the impedance analyzer. The LDV system is used to measure the resonant frequencies of transverse vibrations. However, both the transverse and extensional vibration modes and resonant frequencies of piezoceramic annular disks are obtained by the AF-ESPI method, and the interferometric fringes are produced instantly by a video recording system. Numerical results obtained by finite-element calculations are compared with those from theoretical analysis and experimental measurements. It is shown that the theoretical predictions of resonant frequencies and the corresponding mode shapes agree well with the experimental results. Good agreement between the predicted and measured electrical impedance also is found. The dependence of resonant frequencies and dynamic electromechanical coupling coefficients on the inner-to-outer radius ratio also is analyzed and discussed in this study.