DocumentCode
1177409
Title
Video amplifier design based on op amps
Author
Comer, David J.
Volume
23
Issue
3
fYear
1976
fDate
3/1/1976 12:00:00 AM
Firstpage
169
Lastpage
171
Abstract
A design procedure for video amplifiers is discussed that will 1) determine if a specific op amp can be used to satisfy the design, 2) minimize the number of stages required, and 3) determine individual stage gains required to satisfy the design. A figure of merit, based on device parameters and the specific amplifier requirements, is developed to aid the design procedure. The design procedure is directed toward practical application in that it minimizes component cost, eliminates trial and error methods, and is directly applicable to worst-case design.
Keywords
Operational amplifiers; TV receiver amplifiers; Active filters; Bandwidth; Electrons; Frequency response; Operational amplifiers; Phase control; Phase locked loops; Phase measurement; Process design; Voltage-controlled oscillators;
fLanguage
English
Journal_Title
Circuits and Systems, IEEE Transactions on
Publisher
ieee
ISSN
0098-4094
Type
jour
DOI
10.1109/TCS.1976.1084196
Filename
1084196
Link To Document