Compact antenna test range without reflector edge treatment and RF anechoic chamber

There are several types of CATRs (compact antenna test ranges) used in antenna-pattern measurements. An offset reflector is generally used to generate the quiet zone of a CATR. Serrated edges, rolled edges, or R-cards are generally chosen along the reflector´s edge to reduce the edge-diffraction field inside the quiet zone of the CATR. In order to reduce stray signals from the environment, a high-quality RF anechoic chamber is required for a CATR. In this paper, a new type of CATR, without either a reflector edge treatment or an RF anechoic chamber, is developed. A commercially available DBS (direct-broadcast satellite) reflector antenna, without edge treatment, is used as the reflector antenna of the CATR to generate the quiet zone of the antenna test range. In order to improve the quiet zone´s performance, the fields due to feed spillover, edge diffractions, and other stray signals are gated out by the ITDAMS (impulse time-domain antenna measurement system). The RF interference in the environment can also be reduced by time synchronization and pulse integration of the impulse time-domain antenna measurement system. In order to verify the capabilities of the proposed CATR, three kinds of antennas (a low-directivity horn antenna, a high-directivity 60 cm direct-broadcast satellite reflector antenna, and a 25 cm Ka-band Cassegrain LMDS - local microwave distribution system - antenna) were measured by the proposed CATR. The antenna-pattern results agreed quite well with those of a near-field range and a far-field range.