DocumentCode :
1223590
Title :
Front end electronics for the Jet Drift Chamber
Author :
Lo, C.C. ; Olson, S. ; Bistirlich, J.
Author_Institution :
Lawrence Berkeley Lab., CA, USA
Volume :
36
Issue :
1
fYear :
1989
fDate :
2/1/1989 12:00:00 AM
Firstpage :
462
Lastpage :
464
Abstract :
The Jet Drift Chamber uses a charge-division readout scheme which requires two amplifiers per sense wire. Since there are 690 sense wires, 1380 amplifiers are needed. It follows that each end cap must accommodate 690 amplifiers, which makes packaging and cooling critical problems. To address these problems, 30 six-layer surface-mount boards, each containing 24 (23 used) amplifiers channels, have been fabricated. Each amplifier can accept up to 2 pC of charge and provide a linear differential output of ±300 mV, which is used to drive a twisted-pair transmission line up to 70 ft in length. The power dissipation of each board is 1.5 W
Keywords :
data acquisition; nuclear electronics; position sensitive particle detectors; proportional counters; 1.5 W; Jet Drift Chamber; amplifiers; amplifiers channels; charge-division readout scheme; cooling; front-end electronics; packaging; power dissipation; sense wire; six-layer surface-mount boards; twisted-pair transmission line; Capacitors; Circuits; Crosstalk; Differential amplifiers; Packaging; Power amplifiers; Power dissipation; Power transmission lines; Resistors; Wire;
fLanguage :
English
Journal_Title :
Nuclear Science, IEEE Transactions on
Publisher :
ieee
ISSN :
0018-9499
Type :
jour
DOI :
10.1109/23.34483
Filename :
34483
Link To Document :
بازگشت