Track-Following High Frequency Lateral Motion of Flexible Magnetic Media With Sub-100 nm Positioning Error

Lateral motion of the magnetic tape in data storage applications misaligns the flexible medium relative to the recording head and reduces the potential for decreasing data track width and spacing, and thereby the achievable data storage density. In order to reduce the effect of misalignment between the tape and the recording head, the head is mounted on a track-following actuator that can compensate for the position error up to a frequency that is governed partly by its mechanical resonances; this bandwidth is typically 1 kHz or less for conventional voice coil-based actuators. This paper introduces the design and implementation of a track-following actuator that is piezo-electrically actuated in order to potentially achieve a significant increase of bandwidth and positioning precision. A proof-of-concept is prototyped and experimental results are presented. An H_∞ controller is designed and implemented to compensate for typical disturbances such as periodic runout of packs and rollers, or non-periodic flange impacts. Preliminary closed loop experimental results with an experimental low lateral motion tape path, and conventional servo format and media demonstrate a reduction in positioning error standard deviation to 74.5 nm, with simulations indicating a potential for further improvement to 20.6 nm with the use of improved media and servo format.