A simple method for the evaluation of microwave mixer diodes

A simple method is described for the evaluation of the various microwave mixer diodes which can be used in 9-GHz electron paramagnetic resonance (EPR) spectrometers using magnetic field modulation below 1 kHz. The advantage of this method over other methods is that it is optimized for EPR applications and determines the optimum operating conditions for each microwave diode. This method utilizes a microwave bridge with a reference arm with an attenuator to control the microwave bias power level, and a signal arm where the signal is attenuated, phase shifted, and modulated at the typical magnetic field modulation frequencies. The microwave power from the two arms is recombined and demodulated by the microwave diode. The output of the microwave diode is then recorded with various video loads, microwave bias power, and modulation frequencies. Measurements are performed to determine the effect of the preamplifier that followed the microwave diode on the signal-to-noise ratio (SNR). The recorded spectra are used to determine the SNR, the noise floor, and the 1/f corner frequency. Comparison of these factors for the different types of microwave diodes shows that some Schottky-barrier diodes have noise figures at 1 kHz that are as low as those for tunnel diodes