DocumentCode
1357867
Title
A new concept for finite element simulation of induction heating of steel cylinders
Author
Aniserowicz, Karol ; Skorek, Adam ; Cossette, Christian ; Zaremba, Marek B.
Author_Institution
Dept. of Electr. Eng., Tech. Univ. of Bialystok, Bialystok, Poland
Volume
33
Issue
4
fYear
1997
Firstpage
893
Lastpage
897
Abstract
This paper presents a new algorithm for finite element simulation of induction heating of steel cylinders. Such cylinders have been installed as calender rolls in the Calcoil system for paper plants. This algorithm is used in place of the preprocessor module in EMRC NISA II software. A special preprocessing program has been designed for modeling of a typical section of the cylinder. Computed results are compared to infrared measurements of a laboratory model of a calender roll and, finally, the possibilities of utilizing and developing the algorithm are discussed
Keywords
finite element analysis; induction heating; paper industry; Calcoil system; EMRC NISA II software; calender rolls; finite element simulation; induction heating; infrared measurements; paper plants; preprocessing program; steel cylinders; Coils; Control systems; Electrical equipment industry; Engine cylinders; Finite element methods; Heating; Industry Applications Society; Moisture; Pulp and paper industry; Steel;
fLanguage
English
Journal_Title
Industry Applications, IEEE Transactions on
Publisher
ieee
ISSN
0093-9994
Type
jour
DOI
10.1109/28.605729
Filename
605729
Link To Document