DocumentCode :
1378172
Title :
Microwave noise of DBRT diode over full bias voltage range
Author :
Demarteau, J.I.M. ; Heyker, H.C. ; Kwaspen, J.J.M. ; van de Roer, T.G. ; Kaufmann, L.M.F.
Author_Institution :
Eindhoven Univ., of Technol., Netherlands
Volume :
27
Issue :
1
fYear :
1991
Firstpage :
7
Lastpage :
8
Abstract :
Experimental results on the noise behaviour of a double barrier resonant tunnelling (DBRT) diode are presented. The measurement method had been developed from a standard noise figure meter calibration procedure. Measurements were performed on a stabilised DBRT diode, mounted in a reflection amplifier configuration. The actual circulator in the setup is represented by an ideal circulator and two error networks. Noise figure and noise measure of a DBRT diode at 1 and 1.5 GHz are reported. The bias voltage range includes two positive-conductance regions as well as the intermediate negative-conductance region. In the active region of a 20 mu m mesa diameter DBRT diode, the lowest noise measure observed was 5.5.
Keywords :
electric noise measurement; electron device noise; microwave measurement; resonant tunnelling devices; solid-state microwave devices; tunnel diodes; 1 GHz; 1.5 GHz; 20 micron; DBRT diode; UHF; circulator; double barrier resonant tunnelling diode; error networks; full bias voltage range; mesa diameter DBRT diode; microwave noise; negative-conductance region; noise figure; positive-conductance regions; reflection amplifier configuration; standard noise figure meter calibration procedure; tunnel diode noise measurement;
fLanguage :
English
Journal_Title :
Electronics Letters
Publisher :
iet
ISSN :
0013-5194
Type :
jour
DOI :
10.1049/el:19910005
Filename :
60833
Link To Document :
بازگشت