High efficiency polycrystalline silicon solar cells using low temperature PECVD process

Conventionally directionally solidified (DS) and silicon film (SF) polycrystalline silicon solar cells are fabricated using gettering and low temperature plasma enhanced chemical vapor deposition (PECVD) passivation. Thin layer (~10 nm) of PECVD SiO₂ is used to passivate the emitter of the solar cell, while direct hydrogen rf plasma and PECVD silicon nitride (Si₃N₄) are implemented to provide emitter and bulk passivation. It is found in this work that hydrogen rf plasma can significantly improve the solar cell blue and long wavelength responses when it is performed through a thin layer of PECVD Si₃N₄. High efficiency DS and SF polycrystalline silicon solar cells have been achieved using a simple solar cell process with uniform emitter, Al/POCl₃ gettering, hydrogen rf plasma/PECVD Si₃N₄ and PECVD SiO₂ passivation. On the other hand, a comprehensive experimental study of the characteristics of the PECVD Si₃N₄ layer and its role in improving the efficiency of polycrystalline silicon solar cells is carried out in this paper. For the polycrystalline silicon used in this investigation, it is found that the PECVD Si₃N₄ layer doesn´t provide a sufficient cap for the out diffusion of hydrogen at temperatures higher than 500°C. Low temperature (⩽400°C) annealing of the PECVD Si₃N ₄ provides efficient hydrogen bulk passivation, while higher temperature annealing relaxes the deposition induced stress and improves mainly the short wavelength (blue) response of the solar cells