DocumentCode :
1471292
Title :
High-voltage compressed-gas power transformers
Author :
Hobart, Henry M.
Author_Institution :
Schenectady, N. Y.
Volume :
63
Issue :
9
fYear :
1944
Firstpage :
690
Lastpage :
692
Abstract :
IN a previous article,1 the author pointed cut the many advantages of high-voltage power transmission in compressed gas. Compressed CO2 at the moderate pressure of 40 atmospheres (absolute) has a dielectric strength about 20 times as high as that of air at normal atmospheric pressure, and compressed SO2 at 40 atmospheres about 30 times as high, so that the line conductors need be separated by only a few inches instead of the customary many feet and may, therefore, be enclosed in a reasonably small pipe line. This system offers opportunities for many important cumulative economies in the terminal equipment also, and this paper is devoted to their discussion. It is shown that the use of compressed gas, instead of oil, as the insulating and cooling fluid makes possible power transformers that are only about one fourth as large as the present ones for the same duty, are for all intents and purposes nonaging, and are highly resistant to damage from internal are-overs, besides many other advantages.
Keywords :
Gases; Oil insulation; Power transformer insulation; Shafts; Solids;
fLanguage :
English
Journal_Title :
Electrical Engineering
Publisher :
ieee
ISSN :
0095-9197
Type :
jour
DOI :
10.1109/EE.1944.6440490
Filename :
6440490
Link To Document :
بازگشت