Triggering GaAs lock-on switches with laser diode arrays

Progress toward the triggering of high-power photoconductive semiconductor switches (PCSSs) with laser diode arrays, is reported. An 850-W optical pulse from a laser diode array was used to trigger a 1.5-cm-long switch that delivered 8.5 MW to a 38.3-Ω load. Using 166-W arrays, it was possible to trigger a 2.5-mm-long switch delivering 1.2 MW with 600-ps rise-times at pulse repetition frequencies of 1 kHz. These 2.5-mm-long switches survived 10⁵ pulses at 1.0 MW levels. In single-pulse operation, up to 600 A was switched with laser diode arrays. The goal is to switch up to 5 kA in a single-shot mode and up to 100 MW repetitively at up to 10 kHz. At electric fields below 3 kV/cm GaAs switches are activated by creation of one electron-hole pair per photon. This linear mode demands high laser power and, after the light pulse, the carriers recombine in nanoseconds. At higher electric fields GaAs acts as a light-activated Zener diode. The laser light generates carriers as before, but the field induces gain such that the amount of light required to trigger the switch is reduced by a factor of up to 500. The gain continues until the field across the sample drops to a material-dependent lock-on field. The gain in the switch allows for the use of laser diodes