DocumentCode
1554978
Title
Surface Micromachined Millimeter-Wave Log-Periodic Dipole Array Antennas
Author
Zhou, Hongyu ; Sutton, Nathan Adam ; Filipovic, Dejan S.
Author_Institution
Dept. of Electr., Comput. & Energy Eng., Univ. of Colorado, Boulder, CO, USA
Volume
60
Issue
10
fYear
2012
Firstpage
4573
Lastpage
4581
Abstract
Two wideband millimeter-wave end-fire log-periodic dipole array (LPDA) antennas are designed and fabricated using a sequential surface micromachining. The antennas are excited by monolithically integrating a micro-coaxial line feed in the antenna´s lower boom designed to provide band rejection at 60 GHz. Antennas 1 and 2 are designed to operate in 18-110 GHz and 18 GHz-50 GHz bands, and measured up to 40 GHz and 50 GHz, respectively. VSWR <; 2.5 is obtained for both antennas throughout the measured bandwidth. Measured directivity around 10 dBi and consistent E and H-plane 3 dB beamwidths around 56° and 72°, respectively, are obtained for Antenna 2 throughout its bandwidth. Good pattern correlation between measured and simulated results is also achieved. This paper clearly demonstrates that the wideband high-quality millimeter-wave end-fire LPDAs are now possible.
Keywords
broadband antennas; dipole antennas; micromachining; millimetre wave antennas; frequency 18 GHz to 110 GHz; microcoaxial line feed; pattern correlation; sequential surface micromachining; surface micromachined millimeter-wave log-periodic dipole array antennas; wideband high-quality millimeter-wave end-fire LPDA; wideband millimeter-wave end-fire log-periodic dipole array antennas; Antenna feeds; Antenna measurements; Dipole antennas; Finite element methods; Impedance; Log-periodic antenna; millimeter-wave antenna; surface micromachining; ultrawideband antenna;
fLanguage
English
Journal_Title
Antennas and Propagation, IEEE Transactions on
Publisher
ieee
ISSN
0018-926X
Type
jour
DOI
10.1109/TAP.2012.2207335
Filename
6236043
Link To Document