Hollow-cathode electron source with a fast gas valve

Author

Gleizer, J.Z. ; Krokhmal, A. ; Krasik, Ya.E. ; Felsteiner, J.

Author_Institution

Dept. of Phys., Technion-Israel Inst. of Technol., Haifa, Israel

Volume

1

fYear

2001

Firstpage

706

Abstract

In this paper the parameters of a hollow-cathode electron source and generated electron beam are presented. A gas-puff valve is used to provide a sharp pressure gradient between the cathode cavity and the accelerating gap. Parameters of a He gas and the plasma inside the cathode and the accelerating gap studied by electrical and optical diagnostics for different gas pressure and an amplitude of the discharge current are presented. It was found that the operation of the HC is characterized by a negative anode potential fall and that the plasma density and temperature do not exceed 5/spl times/10/sup 12/ cm/sup -3/ and 14 eV, respectively. Parameters of the electron beam for different discharge current and anode grid cell sizes are presented. It was shown that efficient electron beam generation with an amplitude of the beam current up to 300 A does not lead to significant increase of the plasma potential. The results of the simulation of the HC operation agree with the obtained data.

Keywords

electron sources; plasma density; plasma temperature; 300 A; He; He gas; anode grid cell sizes; cathode cavity; discharge current; efficient electron beam generation; gas-pull´ valve; generated electron beam; hollow-cathode electron source; negative anode potential; plasma density; plasma temperature; sharp pressure gradient; Acceleration; Anodes; Cathodes; Electron beams; Electron sources; Helium; Plasma accelerators; Plasma density; Plasma temperature; Valves;

fLanguage

English

Publisher

ieee

Conference_Titel

Pulsed Power Plasma Science, 2001. PPPS-2001. Digest of Technical Papers

Conference_Location

Las Vegas, NV, USA

Print_ISBN

0-7803-7120-8

Type

conf

DOI

10.1109/PPPS.2001.1002193

Filename

1002193