Modeling and Simulation of A Six Step Discontinuous Current Mode Inverter Fed Permanent Magnet Synchronous Motor Drive Using SIMULINK

Author

Iyer, Narayanaswamy P R ; Zhu, Jianguo

Author_Institution

Faculty of Engineering, University of Technology Sydney, Box 123, Level 24, Broadway; Sydney; NSW-2007, AUSTRALIA, Email: niyer@eng.uts.edu.au

Volume

2

fYear

2005

Firstpage

1056

Lastpage

1061

Abstract

This manuscript describes modelling of a six step discontinuous current mode inverter fed PMSM drive using SIMULINK. The dq-axis voltage-current and torque relation in terms of machine parameters are used to develop the SIMULINK model. A six step 120 degree mode inverter model is newly developed using SIMULINK. Performance test and measurement were conducted on Lybotec six step discontinuous current inverter fed PMSM drive at no load in the laboratory. These values are used in this open loop model. Simulation results for phase advance angle of π/6 and π/4 are given and compared with experimental results.

Keywords

PMSM Drive; SIMULINK Model; Simulation; Six Step 120 Degree Mode Inverter; Australia; Current measurement; Drives; Equations; Inverters; Mathematical model; Optical sensors; Permanent magnet motors; Rotors; Voltage; PMSM Drive; SIMULINK Model; Simulation; Six Step 120 Degree Mode Inverter;

fLanguage

English

Publisher

ieee

Conference_Titel

Power Electronics and Drives Systems, 2005. PEDS 2005. International Conference on

Print_ISBN

0-7803-9296-5

Type

conf

DOI

10.1109/PEDS.2005.1619844

Filename

1619844