CAD procedures for planar re-entrant type couplers and three-line baluns

Author

Tsai, C.M. ; Gupta, K.C.

Author_Institution

Dept. of Electr. & Comput. Eng., Colorado Univ., Boulder, CO, USA

fYear

1993

Firstpage

1013

Abstract

A generalized network model for coupled multiconductor transmission lines is derived based on normal mode parameters. The model is used in the design of planar re-entrant type couplers. By using this network model, the design of a planar re-entrant coupler can be derived from the design of a traditional two-line coupler. The design procedure for single-layer planar baluns using three-conductor transmission lines has also been developed based on this network model. Design procedures and examples are presented.<>

Keywords

circuit CAD; distributed parameter networks; equivalent circuits; impedance matching; linear network synthesis; microstrip components; passive networks; strip line components; waveguide couplers; CAD procedures; coupled multiconductor transmission lines; design procedure; generalized network model; normal mode parameters; planar re-entrant type couplers; re-entrant couplers; three-conductor transmission lines; three-line baluns; Coaxial components; Conductors; Couplers; Coupling circuits; Impedance matching; Microstrip; Multiconductor transmission lines; Planar transmission lines; Transmission line matrix methods; Voltage;

fLanguage

English

Publisher

ieee

Conference_Titel

Microwave Symposium Digest, 1993., IEEE MTT-S International

Conference_Location

Atlanta, GA, USA

ISSN

0149-645X

Print_ISBN

0-7803-1209-0

Type

conf

DOI

10.1109/MWSYM.1993.276893

Filename

276893