CAD of the downconversion and IF amplification parts of a microwave receiver

Author

Abdallah, Esmat A. ; Nassef, Ass Prof Mohammed A ; Sobih, Eng Ayman G

Author_Institution

Electron. Res. Inst., Egypt

Volume

2

fYear

1999

fDate

11/1/1999 12:00:00 AM

Firstpage

519

Abstract

By the aid of the Microwave Design System (MDS), software package, the design and analysis of the downconversion and IF amplification parts of a microwave superheterodyne receiver, operating in the S-band, and the implementation of the designed subsystem in microstrip form, is presented. The designed subsystem has two modes of operation according to the desired application, either a large dynamic range the a high sensitivity mode. All individual circuits constituting this subsystem in the first mode of operation are fabricated separately and their characteristics are measured to test their performances. Then the integration of these circuits on a single substrate is considered and its characteristics are also tested and measured

Keywords

Schottky diode mixers; circuit CAD; intermediate-frequency amplifiers; microstrip circuits; microwave circuits; microwave frequency convertors; microwave mixers; microwave receivers; superheterodyne receivers; CAD; IF amplification; MDS software package; Microwave Design System software package; S-band; circuit integration; downconversion; dynamic range; high sensitivity mode; microstrip form; microwave receiver; superheterodyne receiver; Band pass filters; Circuit simulation; Circuit testing; Design automation; Dynamic range; Integrated circuit measurements; RF signals; Radio frequency; Radiofrequency amplifiers; Software design;

fLanguage

English

Publisher

ieee

Conference_Titel

Microwave Conference, 1999 Asia Pacific

Print_ISBN

0-7803-5761-2

Type

conf

DOI

10.1109/APMC.1999.829923

Filename

829923