Bit Error Probability of Spatial Modulation over Measured Indoor Channels

The Spatial Modulation (SM) transmission scheme boosts the spectral efficiency and achieves the multiplexing gain by activating a single transmit antenna in each time slot. Radio wave propagation characteristics determined by the environment is a decisive factor for the SM system. In this paper, we investigate the performance of the SM scheme over real-world 4×4 Multi-Input Multi-Output (MIMO) channels measured in typical indoor scenarios. Firstly, a MIMO channel sounder is established. Based on the sounder, 15150 complex 4×4 MIMO channel matrices are measured inside a typical teaching building under both Line of Sight (LOS) and None Line of Sight (NLOS) scenarios. Secondly, by comparing the SM system over the measured channel and commonly-used channel models, we prove that both the Independently and Identically Distribute (i.i.d.) Rayleigh and the Spatial Correlation (SC) channel model are oversimplified, and that only practical experiences can yield definitive answers to the achievable real-world system performance. Thirdly, the Average Bit Error Probability (ABEP) performance of the SM system is studied based on the measured data under a variety of system configurations. The study of different receive antenna array settings (4×4, 4×2 and 4×1 MIMO setups) approves the significance of combining scheme at the receiver. SM systems employing different signal constellations (Binary Phase Shift Keying (BPSK), Quadrature Phase Shift Keying (QPSK) and 16 Quadrature Amplitude Modulation (16QAM)) are also investigated and some interesting results are revealed. Lastly, performance assessment of SM against State-Of-The-Art (SOTA) MIMO schemes (Space-Time Block Code (STBC) and Vertical Bell Labs Layered Space-Time (V-BLAST) code) is conducted. Results show that for a 4×4 MIMO, the low-complexity SM scheme outperforms both STBC and V-BLAST.