Computing Ocean Surface Currents Over the Coastal California Current System Using 30-Min-Lag Sequential SAR Images

As compared with conventional methods for measuring ocean surface currents, spaceborne synthetic aperture radar (SAR) offers cloud-penetrating ocean-current observation capability at high spatial resolution. While some studies have shown the potential of SAR for studying ocean surface currents through feature tracking, they have only analyzed a few images to demonstrate the basic measurement technique, and no concise general technique has been developed. This paper shows the application of the maximum cross correlation (MCC) method to generate ocean surface currents from nearly two years of available sequential spaceborne C-band SAR imagery from the Envisat ASAR and ERS-2 Advanced Microwave Instrument SAR sensors over the coastal California Current System. The data processing strategies are discussed in detail, and results are compared with HF radar measured currents. One-dimensional wavenumber spectra of the SAR-derived surface currents agree with the k^-2 power law, as predicted by sub mesoscale resolution models. Comparisons with HF radar currents show encouraging results with MCC SAR vectors oriented slightly counterclockwise relative to HF radar vectors. MCC SAR surface currents are found to have larger magnitudes than HF radar currents (≈11 cm/s), which may be due to the fact that SAR penetrates only a few centimetres into the ocean surface whereas HF radar currents are averaged over the top 1 m of the ocean surface. The larger part of this magnitude difference is contained in the along-shore component, which can be attributed to higher HF radar accuracy in the direct radial cross-shore measurements as compared with along-shore components derived from multiple cross-shore radial measurements.