Measurements of the Flashover Expansion on a Real-Solar Panel—Preliminary Results of EMAGS3 Project

When a primary discharge occurs on a solar array, it is important to understand what would be the maximum flashover expansion. This value would then be representative of in-flight scenarios on full panel size. This paper presents the results of the experimental campaign performed in the frame of the European Space Agency EMAGS3 project “Flash-over evaluation on large solar panels” and where we measure flashovers in different conditions on a real-solar panel. This experimental campaign is conducted in the large vacuum chamber of Industrieanlagen-Betriebsgesellschaft mbH (IABG) (Germany) on a solar panel of 4 × 2 m provided by Astrium-Germany and organized in 52 linear strings of silicon cells covered by Cerium doped borosilicate glass (CMX) coverglasses (CG). During the test, several parameters are studied such as inverted potential gradient (IPG) obtained in plasma or in electrons and test of flashover expansion over a gap between panels by addition of a small panel. The main difficulty is in the evaluation of the value and homogeneity of the initial potential gradient to be able to determine the initial stored charge. The development of a model of flashover expansion has contributed significantly to the comprehension of the results and the assessment of the initial stored charge. During the first step (IPG by electrons at room temperature) ~ 200 electrostatic discharges (ESDs) are recorded of which 12 discharge of the theoretical stored charge in the CG. In IPG by plasma at room temperature, ~ 100 ESDs are recorded, 12 discharging of the theoretical stored charge including two that discharged the panel completely. With this test campaign we demonstrate that, even if the probability is not very high, an ESD on a solar panel could lead a flashover to expand and neutralize the complete surface of an 8- m² panel. In addition, we see that the flashover can continue across a gap of 10 cm.