Research on the optimal cutting parameters for ball end finish milling process of complex surfaces

Author

Shamina, Olga Borisovna ; Belous, Lev Andreevich ; Ogol, Ilya Igorevich

Author_Institution

Inst. of Cybern., Nat. Res. Tomsk Polytech. Univ., Tomsk, Russia

fYear

2014

fDate

16-18 Oct. 2014

Firstpage

1

Lastpage

4

Abstract

The purpose of the present paper is to determine recommendations for complex surface finishing operation with ball end mill. The parameters that influence the roughness are: (i) technological parameters (such as step), (ii) geometrical (radius of milling cutter, angle of surface inclination or tilt angle) and (iii) cutting strategy. Paper presents roughness calculation theory and provide comparison of simulation and experimental data. Finally, recommendations to obtain desirable value of the roughness are given in the paper.

Keywords

ball milling; cutting; surface finishing; surface roughness; ball end finish milling process; ball end mill; complex surface finishing operation; complex surfaces; cutting strategy; geometrical parameter; milling cutter radius; optimal cutting parameter; roughness calculation theory; surface inclination angle; technological parameter; tilt angle; Accuracy; Educational institutions; ball end finish milling; complex surface; cuttinl strategy; milling; roughness;

fLanguage

English

Publisher

ieee

Conference_Titel

Mechanical Engineering, Automation and Control Systems (MEACS), 2014 International Conference on

Conference_Location

Tomsk

Print_ISBN

978-1-4799-6220-4

Type

conf

DOI

10.1109/MEACS.2014.6986952

Filename

6986952