DocumentCode
1831886
Title
Notice of Retraction
3D probe radius compensation in measurement of characterized curves of complex helicoidal surface
Author
Chunxia Lu ; Qicheng Lao ; Qiang Zhu ; Jianhua Wang
Author_Institution
Xi´an Technol. Univ., Xi´an, China
Volume
2
fYear
2010
fDate
1-3 Aug. 2010
Abstract
Notice of Retraction
After careful and considered review of the content of this paper by a duly constituted expert committee, this paper has been found to be in violation of IEEE´s Publication Principles.
We hereby retract the content of this paper. Reasonable effort should be made to remove all past references to this paper.
The presenting author of this paper has the option to appeal this decision by contacting TPII@ieee.org.
Probe radius bias processing is a key technology in CNC measuring center. Based on the principal that the trace of the center of the probe is the offset surface of the measured helicoidal surface, a theoretical model is established for describing the trace surface. And three-dimensional probe radius compensation is proposed. Finally, the measuring example is given. The result shows that the three-dimensional probe compensation is accurate and convenient to measuring characterized curves of complex helicoidal surface.
After careful and considered review of the content of this paper by a duly constituted expert committee, this paper has been found to be in violation of IEEE´s Publication Principles.
We hereby retract the content of this paper. Reasonable effort should be made to remove all past references to this paper.
The presenting author of this paper has the option to appeal this decision by contacting TPII@ieee.org.
Probe radius bias processing is a key technology in CNC measuring center. Based on the principal that the trace of the center of the probe is the offset surface of the measured helicoidal surface, a theoretical model is established for describing the trace surface. And three-dimensional probe radius compensation is proposed. Finally, the measuring example is given. The result shows that the three-dimensional probe compensation is accurate and convenient to measuring characterized curves of complex helicoidal surface.
Keywords
computerised numerical control; diameter measurement; geometry; probes; 3D probe radius compensation; CNC measuring center; characterized curve measurement; complex helicoidal surface; offset surface; three-dimensional probe compensation; Measurement uncertainty; helicoidal surface; offset surface; radius compensation;
fLanguage
English
Publisher
ieee
Conference_Titel
Mechanical and Electronics Engineering (ICMEE), 2010 2nd International Conference on
Conference_Location
Kyoto
Print_ISBN
978-1-4244-7479-0
Type
conf
DOI
10.1109/ICMEE.2010.5558472
Filename
5558472
Link To Document