Analysis of power factor correction isolated SEPIC rectifiers using inductor detection technique

Author

Tanitteerapan, T.

Author_Institution

Dept. of Electr. Technol. Educ., King Mongkut´´s Univ. of Technol., Bangkok, Thailand

Volume

2

fYear

2004

fDate

25-28 July 2004

Abstract

In this paper an analysis of the CCM operated input current waveshaping technique using inductor voltage sensing for power factor correction (PFC) rectifier based on isolated SEPIC converters is introduced. The voltage conversion ratio of the SEPIC converter is used to derive the operation of control circuit. The duty ratio is obtained by comparing an integral signal of the rectified inductor voltage and a negative ramp carrier waveform. The circuit parameters are designed based on operations of SEPIC converter between DCM and CCM. The small signal modeling is determined and used to design output voltage regulator circuit. The proposed analysis is verified by the circuit experimentation of 100 W SEPIC rectifier.

Keywords

power convertors; power factor correction; power inductors; rectifiers; voltage regulators; 100 W; SEPIC converters; SEPIC rectifiers; circuit experimentation; circuit parameters; control circuit; duty ratio; inductor detection technique; inductor voltage; input current waveshaping technique; negative ramp carrier waveform; output voltage regulator circuit; power factor correction; signal modeling; voltage conversion ratio; Circuits; Educational technology; Equations; Inductors; Isolation technology; Power factor correction; Rectifiers; Regulators; Signal design; Voltage control;

fLanguage

English

Publisher

ieee

Conference_Titel

Circuits and Systems, 2004. MWSCAS '04. The 2004 47th Midwest Symposium on

Print_ISBN

0-7803-8346-X

Type

conf

DOI

10.1109/MWSCAS.2004.1354158

Filename

1354158