Analysis of impedance-loaded passive SAW sensor

Author

Genji, Takuma ; Kondoh, Jun

Author_Institution

Grad. Sch. of Eng., Shizuoka Univ., Hamamatsu, Japan

fYear

2014

fDate

19-22 May 2014

Firstpage

1

Lastpage

4

Abstract

In this paper, we describe simulation of an impedance loaded passive SAW sensor. Coupling of mode theory (COM) is used for the simulation. New model for an impedance-loaded passive SAW sensor is proposed. However, the simulated results do not agree with the experimental results. Validity of the COM parameters is discussed and optimum values are estimated using Brent´s method. Then, the model is applied as a novel identification method for SAW devices using a characteristic of a passive SAW sensor. The simulated results indicate the applicability of the new identification method for SAW sensors.

Keywords

estimation theory; surface acoustic wave sensors; Brent method; COM; SAW device; coupling of mode theory; identification method; impedance loaded passive SAW sensor; optimum value estimation; Capacitance; Couplings; Educational institutions; Impedance; Load modeling; Surface acoustic wave devices; Surface acoustic waves; 2-bit ID-tag; Brent´s method; coupling of mode(COM) theory; impedance-loaded passive SAW sensor; optimization of COM parameters;

fLanguage

English

Publisher

ieee

Conference_Titel

Frequency Control Symposium (FCS), 2014 IEEE International

Conference_Location

Taipei

Type

conf

DOI

10.1109/FCS.2014.6859888

Filename

6859888