Study on Minimum Teeth without Undercutting of the Stub Tooth Involute Gears Based on VB

Author

He, Jianing ; Gao, Yong ; Zhang, Haibin ; Zhang, Wei ; Zhang, Chao

Author_Institution

Fac. of Mech. & Electr. Eng., Kunming Univ. of Sci. & Technol., Kunming, China

Volume

1

fYear

2012

fDate

23-25 March 2012

Firstpage

80

Lastpage

83

Abstract

Based on the principle of gear generating, theoretical research and VB software simulation about undercut are presented in this paper. The rack cutter is used to infer minimum teeth without undercutting of stub tooth in volute gear, stub tooth helical gear and stub tooth straight bevel gear. And, which are respectively analyzed and calculated. Thus, correct minimum teeth without undercutting are got, theoretical analysis and calculation on the in volute stub tooth gear have been carried out. Then, minimum teeth without undercutting can be obtained, and use VB software to carry on simulation for verifying the validity of the theoretical calculation.

Keywords

gears; mechanical engineering computing; VB software simulation; gear generating principle; minimum teeth; rack cutter; stub tooth helical gear; stub tooth involute gears; stub tooth straight bevel gear; theoretical research; Benchmark testing; Gears; Presses; Programming; Software; Visualization; VB; gear generating method; minimum teeth; spur gear; stub tooth; undercutting;

fLanguage

English

Publisher

ieee

Conference_Titel

Computer Science and Electronics Engineering (ICCSEE), 2012 International Conference on

Conference_Location

Hangzhou

Print_ISBN

978-1-4673-0689-8

Type

conf

DOI

10.1109/ICCSEE.2012.396

Filename

6187832