DocumentCode :
1973012
Title :
Test results of the SSC log-ratio beam position monitor electronics
Author :
Aiello, G.R. ; Mills, M.R. ; Gonzalez, R.E.
Author_Institution :
Superconducting Super Collider Lab., Dallas, TX, USA
fYear :
1993
fDate :
17-20 May 1993
Firstpage :
2322
Abstract :
A working prototype of beam position monitor (BPM) electronics, based on the log-ratio technique is described in this paper. Results of a test performed at the Fermilab Booster, comparing the existing Fermilab BPM system are also presented. A calibration technique has been used which corrects errors due to mismatched channels and electronics drift. The results are compared with bench measurements on the prototype circuit
Keywords :
calibration; error correction; nuclear electronics; particle beam diagnostics; position measurement; proton accelerators; storage rings; synchrotrons; Fermilab Booster; SSC log-ratio beam position monitor electronics; calibration technique; electronics drift; error correction; mismatched channels; prototype circuit; test results; working prototype; Circuit simulation; Circuit testing; Dynamic range; Electronic equipment testing; Laboratories; Monitoring; Noise figure; Noise measurement; Performance evaluation; Signal to noise ratio;
fLanguage :
English
Publisher :
ieee
Conference_Titel :
Particle Accelerator Conference, 1993., Proceedings of the 1993
Conference_Location :
Washington, DC
Print_ISBN :
0-7803-1203-1
Type :
conf
DOI :
10.1109/PAC.1993.309309
Filename :
309309
Link To Document :
بازگشت