Research and development of KSTAR magnetic diagnostics in the magnetic diagnostic installation chamber

Author

Lee, S.C. ; Bak, J.G.

Author_Institution

Korea Basic Sci. Inst., Taejeon, South Korea

fYear

2003

fDate

5-5 June 2003

Firstpage

483

Abstract

Summary form only given, as follows. Magnetic Diagnostic Installation Chamber (MDIC) which has almost the same dimension of the KSTAR inner shell vacuum vessel cross section was prepared for research and development for KSTAR magnetic diagnostics so that most of magnetic diagnostics are installed and tested in the MDIC before installing in the KSTAR main vacuum vessel. Various clips for installing sample magnetic diagnostics were attached in the MDIC. A sample Rogowski coil, flux loops, saddle loops and magnetic field probes were also installed on the clips. Detailed procedures of the sample fabrications, installation of the sample coils in the MDIC, and technical issues from the sample fabrications will be presented. In addition, 3-D position measurements for the magnetic diagnostics and various clips installed on the MDIC will be reported.

Keywords

Tokamak devices; coils; magnetic field measurement; magnetic sensors; plasma probes; 3-D position measurements; KSTAR Tokamak; Rogowski coil; flux loops; magnetic diagnostic installation chamber; magnetic field probes; saddle loops; Fabrication; High temperature superconductors; Magnetic devices; Magnetic flux; Plasma diagnostics; Plasma measurements; Plasma temperature; Research and development; Superconducting coils; Superconducting magnets;

fLanguage

English

Publisher

ieee

Conference_Titel

Plasma Science, 2003. ICOPS 2003. IEEE Conference Record - Abstracts. The 30th International Conference on

Conference_Location

Jeju, South Korea

ISSN

0730-9244

Print_ISBN

0-7803-7911-X

Type

conf

DOI

10.1109/PLASMA.2003.1230098

Filename

1230098