DocumentCode :
2181222
Title :
SSC collider dipole magnet end mechanical design
Author :
Delchamps, S.W. ; Bossert, R.C. ; Carson, J. ; Ewald, K. ; Fulton, H. ; Kerby, J. ; Koska, W. ; Strait, J. ; Wake, M. ; Leung, K.K.
Author_Institution :
Fermi Nat. Accel. Lab., Batavia, IL, USA
fYear :
1991
fDate :
6-9 May 1991
Firstpage :
2185
Abstract :
The authors describe the mechanical design of the ends of Superconducting Super Collider (SSC) dipole magnets to be constructed and tested at Fermilab. Coil end clamps, end yoke configuration, and end plate design are discussed. Loading of the end plate by axial Lorentz forces is examined. Relevant data from 40 mm and 50 mm aperture model dipole magnets built and tested at Fermilab are presented. In particular, the apparent influence of end clamp design on the quench behavior of model SSC dipoles is described.<>
Keywords :
proton accelerators; storage rings; superconducting magnets; synchrotrons; SSC; Superconducting Super Collider; axial Lorentz forces; collider dipole magnet end mechanical design; end plate design; end yoke configuration; proton synchrotron; quench behavior; superconducting magnets; Apertures; Clamps; Insulation; Laboratories; Lead; Packaging; Steel; Superconducting coils; Superconducting magnets; Testing;
fLanguage :
English
Publisher :
ieee
Conference_Titel :
Particle Accelerator Conference, 1991. Accelerator Science and Technology., Conference Record of the 1991 IEEE
Conference_Location :
San Francisco, CA, USA
Print_ISBN :
0-7803-0135-8
Type :
conf
DOI :
10.1109/PAC.1991.164907
Filename :
164907
Link To Document :
بازگشت