MPRS: Medipix parallel readout system for angiography digital imaging

Author

Fanti, V. ; Marzeddu, R. ; Randaccio, P.

Author_Institution

Dipt. di Fisica, Univ. di Cagliari, Monserrato, Italy

Volume

2

fYear

2002

fDate

10-16 Nov. 2002

Firstpage

944

Abstract

A fast readout system for a low noise CMOS pixel chip, working in single photon counting mode (Medipix2) has been developed for digital angiography applications. Each chip has an active area of about 2 cm², with 256×256 square pixels 55 μm side size, and can be bump bonded to Si or GaAs for direct charge conversion of incoming photons. The system permits the parallel readout of up to 8 chips at a rate of at least 25 frames/s, to allow real time X-ray imaging of contrast medium flowing in blood vessels. The readout electronics is PCI bus-based and consists of two boards, the motherboard directly interfacing the chip for settings and data flow, and the PCI board linking the motherboard to the bus. Dedicated software has been developed to test each single pixel, set configuration patterns and perform data transfer. With parallel readout transfer rate up to 64 MByte/s has been achieved.

Keywords

CMOS image sensors; angiocardiography; biomedical electronics; data acquisition; diagnostic radiography; readout electronics; MPRS; Medipix parallel readout system; Medipix2; angiography digital imaging; blood vessels; configuration patterns; contrast medium; data transfer; fast readout system; low noise CMOS pixel chip; parallel readout; parallel readout transfer; readout electronics; real time X-ray imaging; single photon counting mode; Angiography; Biomedical imaging; Blood vessels; Bonding; Digital images; Gallium arsenide; Joining processes; Readout electronics; Real time systems; X-ray imaging;

fLanguage

English

Publisher

ieee

Conference_Titel

Nuclear Science Symposium Conference Record, 2002 IEEE

Print_ISBN

0-7803-7636-6

Type

conf

DOI

10.1109/NSSMIC.2002.1239479

Filename

1239479