Application of Transient Earth Voltage method in PD detection in GIS

Author

Ming Ren ; Ming Dong ; Zhong Ren ; Hongjie Li ; Aici Qiu

Author_Institution

State Key Lab. of Electr. Insulation for Power Equip., Xi´an Jiao Tong Univ., Xi´an, China

fYear

2011

fDate

6-10 Sept. 2011

Firstpage

313

Lastpage

316

Abstract

This paper discussed the utilization of TEV-Transient Earth Voltage method in PD detection of GIS. The typical defect models in GIS concluding spikes fixed on HV conductor, voids defect in dielectric, suspended metals had been detected by TEV method, PMT, Rogowski monitor and PDCheck system synchronously. The TEV results showed good consistency with other three methods and had a good sensitivity. Based on this, phase distribution of PD, pulse number of different voltage level thresholds and the signal PD pulse characteristic had been obtained in this paper. In addition, the PD of needle-plane with very short gap had been detected under high frequency oscillating impulse voltage using this method.

Keywords

conductors (electric); dielectric materials; gas insulated switchgear; partial discharges; power system transients; GIS concluding spikes; HV conductor; PD check system; PD detection; Rogowski monitor; dielectric metals; high frequency oscillating impulse voltage; phase distribution; pulse number; signal PD pulse characteristic; suspended metals; transient earth voltage method; voids defect; voltage level thresholds; Coils; Current measurement; Discharges (electric); Gas insulation; Metals; Needles; Partial discharges; GIS; PD detection; TEV; partial discharge; transient earth voltage;

fLanguage

English

Publisher

ieee

Conference_Titel

Electrical Insulating Materials (ISEIM), Proceedings of 2011 International Conference on

Conference_Location

Kyoto

Print_ISBN

978-4-88686-074-3

Type

conf

DOI

10.1109/ISEIM.2011.6826295

Filename

6826295