CMOS multiplier design using the differential difference amplifier

Author

Huang, Shu-Chuan ; Ismail, Mohammed

Author_Institution

Dept. of Electr. Eng., Ohio State Univ., Columbus, OH, USA

fYear

1993

fDate

16-18 Aug 1993

Firstpage

1366

Abstract

This paper presents design techniques for a wide range CMOS differential difference amplifier (DDA) and discusses its application as a basic block in the implementation of four-quadrant multipliers and amplitude modulators, which are widely used in analog signal processing. The DDA can be reconfigured as an op amp, and makes use of the op amp-based multipliers, which are well-developed. In addition, it can be shown that the DDA can be implemented as an AM circuit using only a transistor and a resistor. Experimental results obtained from a 2 μm CMOS MOSIS chip are given

Keywords

CMOS analogue integrated circuits; amplitude modulation; analogue multipliers; differential amplifiers; modulators; operational amplifiers; 2 micron; AM circuit; CMOS MOSIS chip; CMOS multiplier design; amplitude modulators; analog signal processing; design techniques; differential difference amplifier; four-quadrant multipliers; op amp-based multipliers; Amplitude modulation; Demodulation; Differential amplifiers; Equations; MOSFETs; Resistors; Signal design; Signal processing; Virtual private networks; Voltage;

fLanguage

English

Publisher

ieee

Conference_Titel

Circuits and Systems, 1993., Proceedings of the 36th Midwest Symposium on

Conference_Location

Detroit, MI

Print_ISBN

0-7803-1760-2

Type

conf

DOI

10.1109/MWSCAS.1993.343359

Filename

343359