Analysis of printed circuit boards including active components based on electromagnetic topology

Author

Park, Yoon-Mi ; Kwon, Ohwook ; Lee, Jung-Yub ; Jung, Hyun-Kyo ; Cheon, Changyul ; Shin, Jin Woo ; Lee, Woo Sang

Author_Institution

Seoul Nat. Univ., Seoul

fYear

2007

fDate

9-15 June 2007

Firstpage

797

Lastpage

800

Abstract

It has been shown that the circuit with the active components is analyzed by using the EMT based on the BLT equation. In order to consider the nonlinear behavior of the diode, the SPICE diode model is applied to the EMT method. The results from the topological modeling are in agreement with the simulation and measured results. In this research, the EMT is based on the circuit simulation, thus it is needed to combine with full-wave simulation for more accuracy.

Keywords

SPICE; circuit simulation; electromagnetic coupling; network topology; printed circuits; BLT equation; EMT method; SPICE diode model; active components; circuit simulation; electromagnetic topology; full-wave simulation; nonlinear behavior; printed circuit boards; Circuit analysis; Circuit analysis computing; Circuit topology; Electromagnetic analysis; Electromagnetic compatibility; Electromagnetic coupling; Equations; Printed circuits; Scattering parameters; Transmission line matrix methods;

fLanguage

English

Publisher

ieee

Conference_Titel

Antennas and Propagation Society International Symposium, 2007 IEEE

Conference_Location

Honolulu, HI

Print_ISBN

978-1-4244-0877-1

Electronic_ISBN

978-1-4244-0878-8

Type

conf

DOI

10.1109/APS.2007.4395614

Filename

4395614