DocumentCode :
2329780
Title :
Ramped voltage testing of transformer oil
Author :
Ren, Diana Hua ; Watson, Alan
Author_Institution :
Dept. of Electr. Eng., Windsor Univ., Ont., Canada
fYear :
1989
fDate :
29 Oct-2 Nov 1989
Firstpage :
363
Lastpage :
368
Abstract :
It has been shown that, compared with dimethyl siloxane, transformer oil has similar reproducible current characteristics as a function of ramped voltage applied up to a high prebreakdown electric stress, where it obeys the equation IVs . Moreover, at a very high electric stress, the displacement current component apparently reverses, which was not previously observed in silicone oil. This abnormal phenomenon is very dependent upon the conditions. From an earlier study in silicone oil, the average current response to the rising and falling voltage appears on a log-log scale with two linear portions which are sharply divided. Transformer oil has similar characteristics under similar testing conditions, but with increasing voltage amplitude of the applied ramp the slopes of the linear portions are changed. These two lines may become one if the maximum voltage and ramp rate are very high. This is true for copper and aluminum electrodes at differing gap separations
Keywords :
electric breakdown of liquids; insulating oils; insulation testing; transformer insulation; displacement current component; high prebreakdown electric stress; ramped voltage testing; reproducible current characteristics; transformer oil; Aluminum; Breakdown voltage; Copper; Electric breakdown; Electrodes; Equations; Oil insulation; Petroleum; Stress; Testing;
fLanguage :
English
Publisher :
ieee
Conference_Titel :
Electrical Insulation and Dielectric Phenomena, 1989. Annual Report., Conference on
Conference_Location :
Leesburg, VA
Type :
conf
DOI :
10.1109/CEIDP.1989.69573
Filename :
69573
Link To Document :
بازگشت