A simple and accurate dynamic voltage divider for resistive bridge transducers

Author

Van der Goes, Frank M L ; Meijer, Gerard C M

Author_Institution

Electron. Res. Lab., Delft Univ. of Technol., Netherlands

fYear

1994

fDate

10-12 May 1994

Firstpage

784

Abstract

This paper presents a simple and accurate dynamic voltage divider for resistive bridge transducers which can be completely integrated in a standard CMOS process. Calibration is not necessary. The division ratio does not depend on the switch resistance of the applied switches. The charge injection and the voltage dependency of the resistors do not have any influence on the performance. Furthermore, the number of components is drastically reduced, compared to traditional dividers. Measurements on an integrated divider in a CMOS process show an accuracy of 13 bits

Keywords

CMOS integrated circuits; bridge circuits; transducers; variable-frequency oscillators; voltage dividers; applied switches; charge injection; division ratio; dynamic voltage divider; integrated divider; resistive bridge transducers; standard CMOS process; switch resistance; voltage dependency; Attenuators; Bridge circuits; CMOS process; Calibration; Force measurement; Pressure measurement; Resistors; Switches; Transducers; Voltage;

fLanguage

English

Publisher

ieee

Conference_Titel

Instrumentation and Measurement Technology Conference, 1994. IMTC/94. Conference Proceedings. 10th Anniversary. Advanced Technologies in I & M., 1994 IEEE

Conference_Location

Hamamatsu

Print_ISBN

0-7803-1880-3

Type

conf

DOI

10.1109/IMTC.1994.351888

Filename

351888