A high-current, very-wide-band transconductance amplifier

Author

Laug, Owen B.

Author_Institution

Nat. Inst. of Stand. & Technol., Gaithersburg, MD, USA

fYear

1989

fDate

25-27 Apr 1989

Firstpage

223

Lastpage

227

Abstract

A novel design approach for a high-current, very-wide-band transconductance amplifier is described. The approach is based on paralleling the input and output of complementary unipolar current-mirror cells. Each cell has a fixed current gain determined by the ratio of two resistors. A differential input voltage-to-current circuit drives the cell array. The design avoids the need for a single low-resistance current-sensing resistor and the attendant problems inherent in such resistors. A prototype of the cell-based transconductance amplifier was implemented with ten positive and ten negative current cells to gain some experimental familiarity with the approach and provide verification of computer simulation results. The prototype transconductance amplifier is DC coupled, has a 3-dB bandwidth of about 750 kHz, and can deliver up to 35 A RMS (root mean square) at 100 kHz with an output voltage of 5 V RMS. Other important characteristics such as output-load regulation and DC offsets are discussed

Keywords

constant current sources; wideband amplifiers; 35 A; 5 V; 750 kHz; calibration; complementary unipolar current-mirror cells; constant current source; current cells; fixed current gain; prototype; very-wide-band transconductance amplifier; voltage-to-current circuit; Calibration; Circuits; Frequency; Instruments; Metrology; NIST; Resistors; Thermal management; Transconductance; Voltage;

fLanguage

English

Publisher

ieee

Conference_Titel

Instrumentation and Measurement Technology Conference, 1989. IMTC-89. Conference Record., 6th IEEE

Conference_Location

Washington, DC

Type

conf

DOI

10.1109/IMTC.1989.36858

Filename

36858