DocumentCode :
2658633
Title :
An experimental arrangement for injection locking Ka-band oscillators
Author :
Eskelinen, H. ; Eskelinen, P.
Author_Institution :
Dept. of Mech. Eng., Lappeenranta Univ. of Technol., Finland
fYear :
2003
fDate :
4-8 May 2003
Firstpage :
524
Lastpage :
527
Abstract :
Two Ka-band oscillators, which have a free-running frequency difference of 20-50 MHz, can be combined as an injection-locked assembly by inserting a waveguide magic-T, an attenuator and a suitably dimensioned ferrite circulator between their respective multiplier outputs. A waveguide mixer is used to detect the phase difference between the two oscillators. In locked state, the mutual frequency can be fine tuned through the adjustment of one of the supply voltages. Because no synthesizers or frequency dividers are involved, the spectrum is practically free of close-in sidebands. Low-noise coarse frequency adjustment up to 10 ppm can be accomplished through water cooling. The proposed arrangement has been tried in selected test instruments and for short-range radar.
Keywords :
ferrite circulators; frequency multipliers; injection locked oscillators; millimetre wave oscillators; radar; waveguide attenuators; 20 to 50 MHz; attenuator; ferrite circulator; free running frequency offset; frequency dividers; injection locking Ka band oscillators; multiplier; noise coarse frequency; radar; water cooling; waveguide magic T; waveguide mixer; Assembly; Attenuators; Cooling; Ferrites; Frequency conversion; Frequency synthesizers; Injection-locked oscillators; Phase detection; Voltage; Waveguide components;
fLanguage :
English
Publisher :
ieee
Conference_Titel :
Frequency Control Symposium and PDA Exhibition Jointly with the 17th European Frequency and Time Forum, 2003. Proceedings of the 2003 IEEE International
ISSN :
1075-6787
Print_ISBN :
0-7803-7688-9
Type :
conf
DOI :
10.1109/FREQ.2003.1275146
Filename :
1275146
Link To Document :
بازگشت