DocumentCode :
2720982
Title :
Experimental measurements of electro-mechanical constitutive behavior of four compositions of PZT
Author :
Stoll, William A. ; Lynch, Christopher S.
Author_Institution :
George W. Woodruff Sch. of Mech. Eng., Georgia Inst. of Technol., Atlanta, GA, USA
Volume :
2
fYear :
1996
fDate :
18-21 Aug 1996
Firstpage :
911
Abstract :
Four compositions of commercially available PZT are characterized under combined stress and electric field loading. The loading consists of a series of increasing compressive stress increments alternating with a series of bipolar electric field cycles. The softest composition has the lowest Young´s modulus and shows hysteresis in the electric field cycle that increases as the compressive stress is increased. A distinct yield stress associated with the onset of deformation twinning (depolarization) is evident at around 25 Mpa. After loading to 180 Mpa and unloading, there is a large residual strain. The hardest composition has a higher Young´s modulus, shows little or no hysteresis in the electric field cycle until the compressive stress has been applied, has a distinct yield point at around 75 Mpa associated with the onset of deformation twinning, and after loading to 180 Mpa and unloading the non-linear strain is recovered. There is no residual strain. The two compositions that lie between the extremes display intermediate behavior
Keywords :
Young´s modulus; dielectric depolarisation; electromechanical effects; hysteresis; internal stresses; lead compounds; piezoceramics; stress-strain relations; twinning; yield point; yield stress; PZT; PbZrO3TiO3; Young´s modulus; bipolar electric field cycles; combined stress/electric field loading; composition dependence; compressive stress increments; deformation twinning; depolarization; electric field cycle hysteresis; electro-mechanical constitutive behavior; nonlinear strain recovery; residual strain; stress/strain curves; yield point; yield stress; Acoustic measurements; Capacitive sensors; Compressive stress; Electric variables measurement; Hysteresis; Mechanical engineering; Residual stresses; Solid modeling; Strain measurement; Stress measurement;
fLanguage :
English
Publisher :
ieee
Conference_Titel :
Applications of Ferroelectrics, 1996. ISAF '96., Proceedings of the Tenth IEEE International Symposium on
Conference_Location :
East Brunswick, NJ
Print_ISBN :
0-7803-3355-1
Type :
conf
DOI :
10.1109/ISAF.1996.598174
Filename :
598174
Link To Document :
بازگشت